In the normal application of hydraulic baler, hydraulic baler is more prone to common problems. The adverse effects caused by slight vibration can destroy all the normal use of the hydraulic baler. So how to solve the vibration problem of the hydraulic baler? Next, Nick Machinery will explain it, I hope it can be helpful to everyone.
1. The hydraulic baler should be installed and disassembled strictly in accordance with the regulations when manufacturing or overhauling. When installing, make sure that there is no air pollution and water seepage.
2. Pay attention to tightening the joints of industrial equipment pipes. Wipe the gasket with vegetable oil during the entire tightening process to avoid deviation and damage of the gasket, and strictly avoid leakage at the joint.
3. When tightening the connecting screws of each part, tighten them with a symmetrical force. When tightening the screws, they must pass through the corners to avoid flange deflection. In addition, please note that the sealing gasket should be symmetrical, and double-layer gaskets
are not allowed.
4. The oil inlet and outlet pipes in the oil tank of the hydraulic baler should be kept at a certain distance to avoid foaming at the oil suction port and noise in the hydraulic oil pump. Of course, you can also lift the baffle in the fuel tank of the car to separate the oil suction port and the oil return port.
5. Avoid secondary pollution when removing debris from the oil filter. The removed filter element should be scraped off with an air pump and cleaned with a diesel engine. If the filter element is seriously polluted, you can consider disassembly and assembly. Also pay attention to whether the volume of the filter is sufficient.
6. The hydraulic filter element must ensure that there is enough vehicle oil, and ensure that it is not lower than the mark line of the oil level gauge. If the remaining oil volume is too low, it will cause the oil pump to run dry and damage the work of the hydraulic oil pump.
Otherwise, the oil pump may be seriously damaged.
7. The hydraulic press commonly used in hydraulic baler belongs to the external control leakage type. In this case, the product should be installed in the pump. One is to maintain a certain working pressure, and the other is to avoid backflow of oil.
The above seven points are all about the methods to solve the vibration problem of hydraulic baling machine. If you are interested in our baler, please contact our staff! 86-29-86031588