Regarding the waste paper baler, when the entire equipment is completed, it may be used for a long time to replace the hydraulic oil.
The hydraulic system needs to be cleaned once. So how do we strive to clean the oil pump of the waste paper baling machine?
1. Organize the environmental site.
2. Use low-viscosity special cleaning oil. When cleaning, add the oil to the oil tank of the hydraulic baler and heat it to 50-80 degrees Celsius.
3. Start the hydraulic pump and let it work empty. During the cleaning process, you must tap the tube lightly to remove the attachments. Clean the oil filter for 20 minutes to check the contamination status, and clean the filter, and then clean it again. Repeat this repeatedly until there is nothing on the filter. Many pollutants stopped.
4. For the more messy hydraulic system, each area can be cleaned according to the work area. The hydraulic cylinder can also be connected to allow the hydraulic cylinder to reciprocate to clean the system.
5. After cleaning, the cleaning oil must be drained as much as possible, and the inside of the oil tank must be cleaned. Then remove the temporary cleaning circuit to restore the hydraulic baler system to normal operating conditions.
Waste paper baling press cxompactor is an environmental protection equipment that uses hydraulic principles to compress waste paper and waste cardboard into blocks, which is beneficial to waste paper storage, transportation and utilization.https://www.nkbaler.com