Phone Number : 86-2986031588
WhatsApp : +8615021631102
August 25, 2021
Marine garbage baler is specially used for packing domestic garbage, waste paper, waste plastic, etc. It is widely used in factories, ships, hotels and tourist resorts.
Today, I will share with you the method of installing the hydraulic oil pump of the marine garbage baler. Let's take a look at it.
Matters in the process of installing the hydraulic oil pump of the marine garbage Baler:
1. The quality of the oil pump device has a very important impact on the smooth operation and service life of the pump. Therefore, the calibration of the device should be carried out carefully and should not be rushed.
The support or base of the hydraulic pump of the marine garbage baler must be strong and strong, and the pump shaft of the hydraulic pump must be aligned with the motor.
2. The device position, length and pipe diameter of the suction pipe of the oil pump should reach the calculated value, and strive to be simple.
The inner diameter of the oil suction pipe should not be less than the requirements of the regulations. The suction pipe should not be too long. The 90-degree bend should not be more than two. It is preferably connected to the oil pump by a soft short connection.
3. The suction and discharge pipelines of the oil pump should have brackets.
4. The address of the oil pump should be spacious to facilitate the maintenance work.
The NICKBALER marine garbage baler is equipped with a liquid tank design, which is suitable for compressing and packing materials with moisture to ensure that the water does not flow to the ground. www.nickbaler.com