google-site-verification=VorvS210A0qn8r0i8uUmYn4MreEamumQ0C84D-yvCd0
Contact Us
NIck

Phone Number : 86-2986031588

WhatsApp : +8615021631102

Kuwait Straw Baler

November 7, 2022

Straw Baler Price
Straw Baler, Alfalfa Baler, Hay Baler

In the process of installing the hydraulic oil pump of the straw baler, we need to pay attention to the following matters:
1. The quality of the oil pump device has a very important influence on the smooth operation and service life of the pump, so the device proofreading operation should be carried out carefully and should not be acted rashly. The support or base of the hydraulic pump should be strong and strong, and the pump shaft of the hydraulic pump should be well aligned with the motor.
2. The installation height, length and pipe diameter of the suction pipe of the oil pump should meet the calculated value, and strive to be simple and reduce the loss (such as elbow number); and ensure that the pump does not exceed its allowable NPSH during operation. The inner diameter of the oil suction pipe should not be smaller than the requirements of the regulations, the oil suction pipe should not be too long, and the 90-degree bend should not exceed two, and the oil pump should not be too long.
The inlet is preferably connected by a soft short connection, and the height of the oil pump is preferably so that the hydraulic oil can flow to the suction port of the oil pump by itself.
3. The suction and discharge lines of the oil pump should have brackets. The pump is not allowed to accept the load of the pipeline.
4. The location of the oil pump of the straw baler device should be spacious to facilitate maintenance operations.
After the hydraulic oil pump of the straw baler is installed, check the temperature and vibration of the bearing during the trial operation as follows: Loosen the coupling and place it on the pump shaft and the base of the electric oil pump with a spirit level. After adjusting the wedge pad, check the level of the unit. Tighten the anchor bolts properly to prevent movement. To prevent debris from entering the pipeline.In the pump, for the pipeline of the new device, a filter should be installed in the pump glue, and its useful cross section should be 2 to 3 times larger than the cross section of the suction pipe.
If you want to master more skills and skills about straw balers, please contact NICKBALER 86-29-86031588

latest company news about Kuwait Straw Baler  0

 

google-site-verification=VorvS210A0qn8r0i8uUmYn4MreEamumQ0C84D-yvCd0