Phone Number : 86-2986031588
WhatsApp : +8615021631102
February 13, 2021
Waste paper baler, horizontal waste paper baler, hydraulic waste paper baler
The NKW180BD waste paper baler of Nick Machinery can choose conveyor belt feeding, air pipe feeding and manual feeding operation modes, which are convenient to operate, safe and reliable.
Emergency stop treatment method during operation of waste paper baler:
1. Check the operation of the pump. If the small waste paper baler is noisy, the needle swing is large, and the oil temperature is too high, the pump may be severely worn.
2. Understand the operating efficiency of the pump. Comparing the temperature of the pump casing and the fuel tank, if the temperature difference between the two is higher than 5°C, the pump efficiency can be considered very low.
3. Check the oil leakage of the pump shaft and joints, and pay special attention to leakage at high temperature and high pressure.
4. Observe the indication value of the vacuum gauge installed at the suction pipe of the pump. During normal operation, its value should be below 127mmhg; otherwise, check the oil filter and working oil of the small waste paper baler.
Nick Machinery has been engaged in the production and research of waste paper hydraulic balers for more than ten years and has rich maintenance experience. Welcome to contact 86-29-86031588, www.nkbaler.com.