waste wiper Baler machine,vertical bagging Baler machine,Wiper Rag Baling Machine

Operation steps of the garment Baler machine:

1. The pressure of this machine has been fully debugged before leaving the factory, as long as the power cord is connected, hydraulic oil is injected, and the following steps are followed, it can be used normally;
2. The machine must be steadily placed on the concrete without swinging. The foundation depends on the local conditions;
3. Check whether the oil discharge port at the bottom of the fuel tank is closed, make sure to close the top of the fuel tank, and then open the sealing cap of the fuel tank top, inject the corresponding hydraulic oil according to the pressure tonnage of the machine. good;
4. If the power cord is connected properly, the motor will rotate during the test. If the pressure plate will not be pressed down, remember to turn off the switch in the electric box first, change the position of the power cord, and try the machine again;
5. If the machine is tested well, exhaust the air in the fuel tank and tubing, and then put the items into the tank for compression and packaging;
6. When the machine is not used for a long time, raise the pressure plate to the top, turn off the switch in the electric box, and then turn off the main power supply.